Best Natural Organic Tomato Fertilizer

Using AGGRAND to Grow Tomatoes

Tomatoes require sufficient levels of macro and micronutrients to set fruit. Calcium (Ca) and potassium (K),
and nitrogen (N) are especially critical. Insufficient levels of these nutrients produce diseased plants and poor
quality fruit. The application of AGGRAND products, biological activators, and/or aerobically composted
manure (or other material), inoculates the soil with microorganisms. The microbes convert natural fertilizer
nutrients and fix atmospheric nitrogen into plant available nutrients, which speeds plant growth and
development.

Soil Applications
Mix 2 to 3 gallons AGGRAND 4-3-3 Natural Fertilizer, 2 to 3 gallons AGGRAND 0-12-0 Natural Liquid Bonemeal,
and 1 to 2 quarts AGGRAND 0-0-8 Natural Kelp and Sulfate of Potash with at least 100 gallons of water.
Apply solution to one acre.
Keep well watered between fertilizations.

Banded Soil Applications
Mix 3 to 4 gallons AGGRAND 4-3-3 with 6 to 10 gallons of water (use enough water to allow correct flow rate
through the micro tubing). Apply below and to the side of the seed or transplants at planting. Apply solution to
one acre. The addition of 1 to 2 gallons of AGGRAND 0-12-0 and 2 to 4 quarts of AGGRAND 0-0-8 along with
4-3-3 may also be beneficial especially when phosphorus soil test levels are below 40 ppm and potassium soil
test levels are below 150 ppm.

Pre-Plant Soil Applications
Mix 3 to 6 gallons of AGGRAND 4-3-3 in 20 to 30 gallons of water. Apply solution to one acre (apply spring
and fall if soil is hard and low in organic matter).

Foliar Applications
Apply AGGRAND 4-3-3 to the leaves of tomatoes to supply additional nutrients.

Mix 1 to 3 gallons of AGGRAND 4-3-3 with 50 to 100 gallons of water and apply as a fine mist to the tops and
bottoms of leaves. Apply enough solution to wet the leaf surfaces. Apply in 14 to 21 day intervals after the
plants reach 2 to 3 true leaves. The critical stages for foliar applications are 2 to 3 true leaves; pre-bloom and
early cluster formation.

Rates vary according to other inputs that are applied. Lower dilution rates are more effective than higher
dilution rates. Two or three lighter applications may be more effective than one or two heavier applications. If
other constraints allow only one application, then do not exceed a 3 percent dilution rate (3 gallons of
AGGRAND to 100 gallons of water).

The addition of a biodegradable surfactant increases uptake by increasing adhesion to the leaf surface. Apply
AGGRAND in early morning or late evening. Do not apply before or after rainfall or irrigation. On standard field
sprayers, use turbo flood jet nozzles when applying AGGRAND to reduce clogging.

AGGRAND Guide To Great Tomatoes

• Plant oats or rye for a cover crop.
• Mow and till the cover crop into the soil.
• Soak tomato plants overnight in a mixture of two ounces AGGRAND Natural Liquid 4-3-3 Fertilizer
pergallon of water.
• Remove the bottom two leaves from the plant and bury it up to the place where the leaves were pulled off.
• Make a round mound of dirt around each plant to direct AGGRAND fertilizer and water directly to the plant.
• Use strong wire cages to support the plants.
• Apply a mixture of three ounces of 4-3-3 to a
gallon of water on each plant twice a month.
• When small tomatoes appear, encourage production
of larger tomatoes by removing some from
the plants.
• Apply a mixture of three ounces of AGGRAND
0-12-0 Liquid Bonemeal to one gallon of water
every two weeks.
• When plants are about 2-feet high, foliar feed
them twice a month until all the leaves are wet.

Get a FREE 6 Month Preferred Membership Buy Wholesale - Save 25-30% Just fill in your name and email below and click submit OR call us at 573-690-2343.
Name:
Email: